Baseline-systems BL-PFS200 Flow Sensor Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Capteurs Baseline-systems BL-PFS200 Flow Sensor. Baseline Systems BL-PFS200 Flow Sensor User Manual [en] Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 3
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
BL-PFS100, BL-PFS150, & BL-PFS200
Two-Wire Ready Flow Sensor Installation
1-866-294-5847 Rev 03262013 www.baselinesystems.com
Baseline’s BL-PFS100, BL-PFS150, and BL-PFS300 are PVC tee-type, impeller flow sensors that
provide accurate digital output signals proportional to the velocity of the liquid flowing
through the pipe.
Installation Overview
1. Choose the proper location and
orientation.
2. Install the sensor in the pipe.
3. Make the electrical connections.
4. Program the controller.
Operation Notes
Make sure the flow sensor is assembled and the retaining nut is tightened (hand tight)
before pressurizing the system.
Fill the pipeline and eliminate all trapped air.
The flow sensor should begin transmitting flow immediately; however, it may take up to
a minute for the flow readings to display in the appropriate screens on the BaseStation
controllers.
Always wait for flow to stabilize before setting control limits. Stabilization may take
several minutes in large piping systems.
Vue de la page 0
1 2 3

Résumé du contenu

Page 1 - Operation Notes

BL-PFS100, BL-PFS150, & BL-PFS200 Two-Wire Ready Flow Sensor Installation 1-866-294-5847 Rev 03262013

Page 2

Choosing the Proper Location and Orientation Because an impeller sensor measures the velocity of the liquid and converts it to a flow measurement base

Page 3 - Programming the Controller

Installing the Sensor in the Pipe The PVC flow sensor tee features socket ends intended for solvent welding into PVC piping systems. Use best industry

Commentaires sur ces manuels

Pas de commentaire