Baseline-systems BL-5201PR Pump Start/Stop biCoder Manuel d'utilisateur télécharger pdf

BL-5201PR Pump Start/Stop biCoder

Installation Guide

Wire Descriptions

 Red and black wires: Connect to the two-wire path

 Gray wire: Normally open wire that is used to turn a relay on or to close a switch

 Gray wire with the black stripe: Normally closed wire that is used to turn off a relay or to

open a switch

 White wire with the black stripe: Common wire

The BL-5201PR biCoder can also be used to for the following:

 Turn off a relay

 Open a switch

 Close a switch

Refer to the instructions on the back page for installation instructions for these alternate uses.

1-866-294-5847 Rev 11.26.2014 www.baselinesystems.com

Instructions for Using the BL-5201PR to Turn On a Pump Relay — Activating a Normally Open Relay

1. Connect the red and black wires on the biCoder to the red and black wires from the two-wire

path that connects to the controller. Polarity matters! All connections must have DBR/Y or

equivalent connectors.

2. Connect the gray wire from the BL-5201PR biCoder to one wire from the 24VAC transformer.

3. Connect the other wire from the transformer to the relay.

4. Connect the white wire with the black stripe from the BL-5201PR biCoder to the common wire on

the relay.

5. Cap the gray wire with the

black stripe.

6. Configure the BL-5201PR in the

controller.

1 2

BL-5201PR Pump Start/Stop biCoder Installation Guide Wire Descriptions  Red and black wires: Connect to the two-wire path  Gray wire: Normally o

Page 2

Using the BL-5201PR to Close a Switch 1. Connect the red and black wires on the biCoder to the red and black wires from the two-wire path that connec

Pas de commentaire

Baseline-systems BL-5201PR Pump Start/Stop biCoder Manuel d'utilisateur